![]() ![]() The reason you want to do this is because you make it obvious to the defenders behind you that there’s a seam in the block and they’ll know to step up and defend this gap. If the setter sets the ball to the antennae fairly quickly and you realize you won’t quite make it all the way out in time to make a good double block, just go up to block wherever you are when the attacker is spiking – even if there’s a big seam between you and the other blocker. ![]() It’s Better To Not Get Far Enough Out Than To Put Up A Sloppy Block Of course some sideways drift will be unavoidable.ħ. You should almost be going straight up from wherever you take off from. It’s incredibly annoying if you’re and opposite/outside and whenever you go up to block, you’ve got a 250lb 6’10” middle blocker shoulder barging you in mid air every time!Įven when swing blocking, focus on going into the jumping movement with little to no horizontal momentum. What ends up happening is the middle blocker crashes into the shoulder of the other blocker and often completely takes them out. Sometimes, when the ball is set to the sticks quickly, the middle blocker will jump from too far inwards and float out in an attempt to close the seam in mid air. If a ball is set out to the pins, your job as the middle is to quickly get into position to form a double block with your wing player. I see this all the time from inexperienced middle blockers. The above hand signal would mean you’re planning on commit blocking to the right hand side of the court. You should be aware of which direction your opponent likes to hit the ball, so naturally you’ll look to block that part of the court.Įven if you don’t have a read on where they’re going to hit the ball, just pick a direction anyway as it’ll allow your defenders to better defend the open court. With your other hand, indicate which way you’re going to block by pointing. To signal a commit block, make a closed fist. To signal a commit block, make an open palm. If they’re not causing too many problems and aren’t being set all that often, read blocking may be a better approach. If our opponent is being set a lot and is very strong, a commit block may be the best approach in an attempt to neutralize them as a threat offensively. ![]() You want to tell your defenders what direction you’re planning on blocking and whether you’re going to commit block or read block.Ī commit block simply means you’re going to jump aggressively to block the opposing middle if the pass is reasonably accurate.Ī read block means you may or may not jump to block the middle, but you’re going to decide as the ball makes its way in to the setter. When your team is serving, it helps to communicate to your back court via hand signals behind your back to ensure everyone’s on the same page. ![]() You’re standing opposite him in position 3. Imagine you’re up against a really solid opposition middle blocker who is destroying you offensively. This is primarily a beach volleyball tactic that works really well on the indoor volleyball court too. Use Hand Signals To Communicate To The Back Court ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |